Table of Contents
Advertisement
Stamping (optional)
Stamping (optional)
Introduction
Stamping is an Océ TDS700 option which allows you to print a pre-defined text on
all your copies. Stamping is enabled in the Océ TDS700 Power Logic
application. The key operator can predefine a maximum of 50 stamps in the Océ
TDS700 Power Logic
You can select one stamp per original and you can select the Colour, Font size and
Position. A stamp can consist of the following parts.
pre-defined text
■
date
■
time
■
Illustration
[124]
[124] Set the stamping options
How to select a stamp
Open the 'Stamping' card in the 'Copy' section.
1.
Select stamp 'On' with the 'Enable' function key.
2.
Select a stamp with the 'Select stamp' function key.
3.
Note: The following steps are optional.
Select a 'Colour' with the 'Format stamp' function key and the arrow keys.
4.
Select a 'Size' with the 'Format stamp' function key and the arrow keys.
5.
Select a 'Position' with the 'Stamp position' function key and the arrow keys.
6.
Result
The output will contain a stamp to indicate for example its status as a draft or
classified document.
198
Chapter 4 Use the Océ TDS700 productive scanner
®
controller application.
®
controller
Advertisement
Table of Contents
