Maintain The Printer; Media; Load Rolls Of Media - Oce TDS700 User Manual

Load rolls of media

Maintain the printer

Media

Load rolls of media
Introduction
When a roll is empty during a print job, a 'Roll empty' indication is displayed on the
printer operator panel and on the status bar of the Océ TDS700 Power Logic
controller application. You then have to load a new roll of media.
If you load new print media, you must tell the system the size of the material and the
type of print material (paper, transparent, or polyester).
Currently the following media are supported on the Océ TDS700.
Plain paper (Red label plus) 64g/m2
■
Plain paper (Red label plus) 75g/m2
■
Plain paper (Red label) 110g/m2
■
Transparent paper 90-95g/m2
■
Polyester film (CPRF) 3.5mil
■
Polyester film 4.5mil
■
Vellum (9020/9022) 20lbs.
■
When you load the media, you can place one roll at a time conveniently on top of the
printer. Two protruding roll retainers prevent the roll from dropping off the printer.
354 Chapter 10 Maintain the Océ TDS700
®