Table of Contents
Advertisement
Make a copy and remove a strip
Make a copy and remove a strip
Introduction
You can use a strip to file a drawing. Use 'Add strip' to copy an original without a
strip and add a strip to the copy. Use 'Remove strip' to copy an original with a strip
and remove the strip from the copy. You can adjust a strip at the leading or trailing
side of a copy.
Before you begin
If you must enter the same value for a setting very often, you can set this value as the
default value for that setting in the Océ TDS700 Power Logic
application.
After you press the start key, the scanner operator panel always shows the job
number and status of the job. A copy job appears temporarily in the 'Scheduled jobs'
in the Océ TDS700 Power Logic
in the selected destination of the 'Scan jobs' workspace.
Attention: When you remove a strip, make sure that you copied all the required
information.
How to make a copy and remove a strip
Place the original face down and right aligned.
1.
The scanner takes the original.
Define the job settings.
2.
Select 'Copy' with the upper-left softkey.
■
The copy job templates appear.
Open a copy job template with a left softkey.
■
The top 5 settings appears.
Scroll to 'Remove strip' and open this setting with the left softkey.
■
Select 'Leading' or 'Trailing' with the left softkey and define the value with the
■
scroll wheel or numeric keys.
[16]
[63]
The 'Leading' strip
Define the number of copies if necessary and press the green start key.
3.
116
Chapter 3 Use the Océ TDS700 flexible scanner
®
controller application, a scan-to-file job appears
[64]
The 'Trailing' strip
®
controller
Advertisement
Table of Contents
