Start the Océ TDS700 Power Logic® application with Océ TDS700 Power Logic
Start the Océ TDS700 Power Logic
TDS700 Power Logic controller Remote
Introduction
Use the following 2 methods to start the application with Océ TDS700 Power Logic
controller
Use the programs menu of your operating system.
■
Use a command line parameter.
■
Use the programs menu to start the Océ Power Logic
1. Select 'Start'.
2. Select 'Programs'.
3. Select TDS700 Power Logic controller application Remote.
The application starts with your default system.
Note: You can select another system than your default system
controller' on page
Use command line parameters to start the applications
Six command line parameters are available to facilitate the start of the applications.
configfile=<config_file>
■
Sets the configuration file to use.
server=server
■
Sets the indicated server as the server to connect to.
language1=lang
■
Specifies the first language in combination with the parameter
country1=country .
country1=country
■
Specifies the first language in combination with the parameter
language1=language .
language2=lang
■
Specifies the second language in combination with the parameter
country2=country .
country2=country
■
Specifies the second language in combination with the parameter
language2=language .
®
Remote.
240).
®
application with Océ
®
controller application
(see 'Connect to the
237