Use The Manual Feed Function For Copy Jobs; Copy Jobs On Pre-Cut Sheets - Oce TDS700 User Manual

Use the manual feed function for copy jobs

Introduction
If you want to copy a job on a media type or size that is not available on one of the
paper rolls or sheet feeders, it can be convenient to manually feed sheets instead of
switching paper rolls or sheet feeders. The sheet feed is a special slot just above the
roll drawers on the printer. You can insert pre-cut copy material in this slot, one sheet
at a time.
Illustration
[121]
[121] Define the manual feed setting

Copy jobs on pre-cut sheets

Open the 'Sheet' card in the 'Copy' section.
1.
Press the 'Manual feed' key to change the setting to 'On'.
2.
Note: If templates are present on the scanner, open the 'Preferences' section to
access the 'Manual feed' setting.
Select any required other settings.
3.
Enter the number of copies using the numeric keys.
4.
Feed the original.
5.
Press the start key.
6.
Take your sheet of copy material to the side of the printer that contains the sheet feed.
7.
Use both hands to align the copy material in accordance with the format indication
and the sticker on the manual feed table.
Move the copy material forward in the nip of the roller. This action must cause an
8.
ample paper bulge over the full width of the page. Hold the paper with both hands
until the printer pulls in the first part of the sheet. The bulge will be reduced or it
will disappear. A few seconds later the complete sheet will be pulled in the printer.
Note: If the copy job requires more sheets, the display will ask you to feed the next
sheet.
Repeat steps 7 and 8 to complete the job.
9.
Use the manual feed function for copy jobs
193