Empty the waste box
Introduction
If a reinforcement unit is installed, the protective sheet from the reinforcement tape
is stored in a waste box. For each roll of tape, you must empty the box twice.
Note: You can empty the waste box while the printer is running.
Empty the waste box
Open the waste box.
1.
First pull the waste box to the left hand side.
■
Next pull the waste box to the front'.
■
[201]
[201] Opening the waste box
Empty the box.
2.
Close the waste box.
3.
First push the waste box forward.
■
Next push the waste box to the right hand side.
■
[202]
[202] Closing the waste box
Empty the waste box
329