Replacing The Romb Battery Pack For The Mezzanine Raid Card - Gateway E-9425R User Manual

8
9
10
11
12
13
14
Replacing the ROMB battery pack for the
mezzanine RAID card
or equivalent type recommended by the manufacturer. Dispose of or recycle used batteries
by taking them to a hazardous waste facility. Follow all local regulations for correct battery
disposal.
To replace the ROMB battery pack for the mezzanine RAID card:
1
2
50
CHAPTER 4: Installing Components
Caution
Pressing or pulling on any components on the backplane could result in
damage to the backplane.
Caution
Make sure that you do not pinch, bind, or damage any cables as you install
the backplane.
Holding the new backplane by the edges only, align it with the locking tabs on the chassis,
then place it on the locking tabs and slide it to the left until it stops.
Tighten the thumbscrew to secure the backplane.
Reconnect all cables to the backplane.
Replace the fan board and system fans by following the instructions in
fans" on page 41.
Follow the instructions in
Reinstall the hot-swap drives back into the server. Make sure that you install the drives
into the same bays you removed them from in
installing a hard drive" on page
Replace the bezel by snapping it into place on the front of the server.
Warning
Danger of explosion if the battery is incorrectly replaced. Replace only with the same
Follow the instructions in
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
Follow the instructions in
"Closing the server case" on page
Step
33.
"Preventing static electricity discharge" on page
"Opening the server case" on page
"Replacing system
30.
4. For instructions see "Removing and
28. Make sure
29.