Installing And Removing An Optional Mezzanine Board - Gateway E-9425R User Manual

3
4
5
6
Installing and removing an optional mezzanine
board
This server has two types of optional mezzanine boards. They include a 2-channel SAS mezzanine
board, and 2-channel SAS mezzanine board with RAID. They are designed to provide extra HDD
storage capability with one 160-pin mezzanine board connector. Each type of mezzanine board
uses the specific chipset for optimal features and provides expansive storage by connecting with
the extra drives.
To install an optional mezzanine board:
1
2
3
www.gateway.com
Press the release handle (1), then slide the ROMB battery pack for the mezzanine RAID card
(2) toward the back of the chassis to release it from the locking tabs and lift it out of the
chassis (3).
Align the holes in the bottom of the new ROMB battery pack for the mezzanine RAID card
(1) with the locking tabs in the chassis, then press it into place in the chassis.
Slide the ROMB battery pack for the mezzanine RAID card (2) toward the front of the chassis
until it clicks into place.
Follow the instructions in
Follow the instructions in
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
Follow the instructions in
Remove the PCI riser assembly by following the instructions in
PCI expansion cards" on page
"Closing the server case" on page
"Preventing static electricity discharge" on page
"Opening the server case" on page
39.
30.
28. Make sure
29.
"Installing and removing
51