Table of Contents
Advertisement
•
•
•
•
Opening the server case
unplug both power cords.
Because the components inside your server are extremely sensitive to static electricity, make
sure that you follow the instructions at the beginning of this chapter to avoid static electricity
damage.
cabinet rails. You must support the server while removing the front screws and while sliding
the server off the cabinet rails. If the server is not supported, damage to the server or
injury may
To open the server:
1
2
3
4
5
6
www.gateway.com
Avoid static-causing surfaces such as carpeted floors, plastic, and packing foam.
Avoid working on the server when your work area is extremely humid.
Remove components from their antistatic bags only when you are ready to use them. Do
not lay components on the outside of antistatic bags because only the inside of the bags
provide electrostatic protection.
Always hold expansion cards by their edges or their metal mounting brackets. Avoid
touching the edge connectors and components on the cards. Never slide expansion cards
or components over any surface.
Warning
This server may have two power cords. To disconnect internal AC power, you must
Warning
Screws are required to support the front of the server when using the standard
result.
Follow the instructions in
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
If the bezel is installed, unlock it, then pull it off.
If the server is mounted in a cabinet, remove the server from the cabinet. For instructions,
see
"Removing the server from a cabinet" on page
Place the server on a stable, non-skid surface.
Remove the screw (1) at the front of the rear top cover (3), then press and hold the release
button (2).
Important
The hard drive carriers shown in these illustrations may look different than
the actual hard drive carriers in your server.
Slide the rear cover (3) toward the back of the case, then lift it off the case.
"Preventing static electricity discharge" on page
28. Make sure
15.
29
Advertisement
Table of Contents
Troubleshooting
