Replacing The Power Cage - Gateway E-9425R User Manual

7
8
9
10
11

Replacing the power cage

To replace the power cage:
1
2
3
4
5
48
CHAPTER 4: Installing Components
Align the new power distribution board with the stand-off and locking tabs on the chassis,
then place it on the stand-offs and slide it toward the side of the chassis until the tab clicks
into place.
Replace the screw you previously removed.
Reconnect the power cables. See
connectors on the system board.
Reinstall the power supply modules by following the instructions in
supply module" on page
Follow the instructions in
Follow the instructions in
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
Follow the instructions in
Remove the power supply modules by following the instructions in
supply module" on page
Remove the power distribution board by following the instructions in
hot-swap backplanes" on page
Loosen the screws (3) holding the power cage in the chassis.
"System board" on page 4
46.
"Closing the server case" on page
"Preventing static electricity discharge" on page
"Opening the server case" on page
46.
49.
for the location of the
"Replacing a power
30.
28. Make sure
29.
"Replacing a power
"Replacing the