Recovering The Bios - Gateway E-9425R User Manual

Recovering the BIOS

If you encounter a problem while you are updating the BIOS, such as a power outage, the BIOS
update may not be successful. If the system continues to try to boot from the new, corrupted
BIOS, you can manually recover the old BIOS so you can try another update.
To recover the old BIOS:
1
2
3
4
To manually recover the BIOS:
1
2
3
4
5
6
7
8
9
10
www.gateway.com
Important
This method does not work if the keyboard is connected through the KVM switch.
Insert a diskette, CD or DVD, or a bootable USB "disk-on-key" containing the AMIBOOT.ROM
file.
Turn on or restart the server. Press and hold C
process begins (the server beeps). The process is complete when you see a message on
the screen.
Remove the diskette, the CD or DVD, or the bootable USB "disk-on-key."
Restart the server. The old BIOS is recovered.
Follow the instructions in
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
Caution
Moving the jumper while the power is on can damage your server. Always
turn off the server and unplug the power cords and all other cables before changing
the jumper.
Follow the instructions in
Remove the jumper across pins 1-2 of header J3-E, then place the jumper across pins 2-3.
Follow the instructions in
Insert a bootable USB "disk-on-key" containing a valid BIOS image into a USB port.
Reconnect the power cords and turn on the server. The BIOS recovery is initiated.
Wait until the BIOS recovery is completed. The process may take up to 5 minutes.
Remove the bootable USB "disk-on-key."
Turn off the server, then disconnect the power cords and all other cables connected to
the server.
Follow the instructions in
+H
TRL OME
"Preventing static electricity discharge" on page
"Opening the server case" on page
"Closing the server case" on page
"Opening the server case" on page
during power up until the recovery
28. Make sure
29.
30.
29.
59