Installing A 5.25-Inch Device - Gateway 8450R System Manual

Installing a 5.25-inch device

The chassis supports a single half-height 5.25-inch device. The 5.25-inch drive
bay is in the center of the front panel (see "System board" on page 13.)
To install a 5.25-inch device:
1
Turn off the server and disconnect the power cord and all other external
peripheral devices.
2
Remove the bezel. (See "Removing the bezel" on page 27.)
3
Remove the front top panel. (See "Removing the front top panel" on
page 29 and "Preventing static electricity discharge" on page 25.)
4
Pull out the metal electro-magnetic interference (EMI) shield from the
front of the 5.25-inch drive bay and save it in case you need to remove
the 5.25-inch device you are installing.
5
Install the drive rails on the 5.25-inch device. (See the documentation
that came with the device for any jumper settings and cable orientation
information.)
49
Drives