CHAPTER 4: Installing Components
Closing the server case
Important
The hard drive carriers shown in these
illustrations may look different than the
actual hard drive carriers in your server.
32
Press down the two blue retaining clips (1) on the sides of the top front
7
cover, then slide the top front cover back (2) and lift it off the server.
To close the server case:
Make sure that all of the internal cables are arranged inside the case so
1
they will not be pinched when you close the case.
Place the front top cover on the case and slide the cover forward, then
2
lift the two blue retaining clips into place.
Place the rear top cover (1) on the case, then slide it forward until it clicks
3
into place.
www.gateway.com