Aud1Lang And Aud2Lang Menus - Motorola DSR-6403 Operator's Manual

3
If the unit's configuration can be edited, the following caution messages appear:
• A caution message is displayed when changing from a Virtual Channel (DCII Selection Mode)
to a MPEG program number (MPEG Selection Mode). Press any arrow button ( 4 ) to
back out of the field and leave it unchanged. Otherwise, press ENTER to proceed.
• A caution message displays when an MPEG program number is selected which does not exist
within the acquired source signal or transport stream.
Press any arrow button ( 4 ) to back out of the field and leave it unchanged. Otherwise,
press ENTER to proceed.

AUD1LANG and AUD2LANG Menus

CAUTION: Making changes to this menu will briefly interrupt all MPEG2 service outputs (ASI Out
2 and GigE). When turned on, the ad insertion signals can be sent to the local headed equipment.
These menus (Audio1 and Audio2 Language) have three fields to modify and view the status of
the language for the Audio1 and Audio2 outputs. Also, use this menu to view the mode of the
audio signal as it is received from the programmer and before any subsequent down mixing that
the unit may perform. Press the  buttons until the desired menu appears (either AUD1LANG
or AUD2LANG).
These menus also govern and display the audio tracks used when transcoding to MPEG2 video
output via ASI OUT 2 output port and transcoded GigE output port. Up to two audio tracks are
passed with each transcoded service (i.e., AUD1LANG and AUD2LANG).
54
CAUTION: Changing to MPEG selection mode
Press E to continue or
CAUTION: Program ddddd does not exist
Press E to continue or
AUD1LANG Dspl Left
E All eng00
AUD2LANG Dspl Left
E All eng00
to stop
to stop
Right InputMode
eng00 ---
Right InputMode
eng00 ---