Mode Field; Xpndr Field - Motorola DSR-6403 Operator's Manual

Dsr-6400 series satellite multiplex receiver/transcoder
Table of Contents

Advertisement

The following screen prompts the user to confirm the selection and exit the field.
If you press any arrow button ( 4 ) at this point, the Caution screen disappears and the
MANUAL TUNE menu reappears without any changes. To set the port selection, press ENTER.

Mode Field

The Mode field allows selection of the frequency plan type for the satellite signal to which the
unit is tuned. If the application is a North American C-band satellite center frequency, select the
transponder number in the Xpndr field. Otherwise, set this field to LFreq and also set the new
field (LFreq) as described on page 34. The L Freq option can be used for all satellite LNB signals,
including C-band and Ku-band.
Press the 4 button until the cursor is on the Mode label. Then press ENTER to move into the field.
There are two choices: Xpndr and L Freq. Press the  buttons to display the desired choice.
Then press ENTER to confirm the selection and exit the field.
If Xpndr is selected, choose a transponder in the Xpndr field. The frequency in the LFreq field is
set automatically and cannot be edited.
If L Freq is selected, the Xpndr field no longer appears because the transponder/ frequency
relationship is not known. Select a transponder frequency between 950 and 2150 MHz in the
LFreq field. This field is not available when Input field is set to either ASI In or GigE In.

Xpndr Field

This field is not available when Input field is set to either ASI In or GigE In. This field is not
available when the Mode field is set to LFreq.
This field allows selection of an initial satellite transponder number and can only be used if the
Xpndr option in the Mode field is selected. Press the 4 button until the cursor is at the Xpndr
label. Then press ENTER to move into the field.
Then press the  buttons to select the desired transponder number. Since the associated
transponder/frequency tables are stored in the unit, scroll through the transponder numbers and
notice that the associated frequency (shown in the LFreq field to the right) automatically changed
with the selection (970-1430 MHz). There are 24 transponder options, and when the desired
transponder selection is displayed, press ENTER to confirm selection and move the cursor back
up to the field label.
DSR-6400 Series
CAUTION: Service will be interrupted
Press E to continue or
Default: Xpndr
to stop
33

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dsr-6402Dsr-6401Dsr-6404

Table of Contents