Xpndr Field; Mpeg Select Menu; Pr Field (Dsr-6402, Dsr-6403, And Dsr-6404 Only); Program Field - Motorola DSR-6403 Operator's Manual

Xpndr Field

This non-editable field displays the current (Xpndr) transponder name (alpha/numeric) that is
downloaded. If a Virtual Channel is selected that is not in the chosen VCT, then a warning message,
(Not in map) is displayed to the right of the Virtual Channel. This field serves as a label or identifier
for the signal source.

MPEG SELECT Menu

Use this menu as an alternative to VCT and Channel (DCII Selection Mode) by specifying the
MPEG program number(s). Press the  buttons until the MPEG SELECT menu appears. The
MPEG program number can be used instead of a Virtual Channel, but only if the unit is already
tuned to the appropriate L-band, ASI, or GigE input signal.

PR Field (DSR-6402, DSR-6403, and DSR-6404 only)

The PR (processor) field does not appear on a DSR-6401. Press the 4 button until the cursor is at
the PR label, and press ENTER to move into the field. Press the  buttons to scroll throughout
the available processor values. Press ENTER to confirm the selection and exit the field. Each PR
number has its own Program field for manual assignment to each processor path.
Note: Changing this value will change all other PR fields throughout this unit's menu system to
the same value that is set here.

Program Field

Press the 4 button until the cursor is at the Program label, and press ENTER to move into the
field. While ensuring that the cursor remains on the up/down symbol ( ), press the  buttons
to scroll throughout the available MPEG programs. (If the current L-band or ASI input signal
contains four MPEG programs, then only four MPEG programs appear in this field.) Press
ENTER to confirm the selection and exit the field.
This field also provides a second method for selecting the MPEG program(s). Use the 4 buttons
to select the digit to change and then, while the cursor is on that digit, press the  buttons to
display the required value. Repeat this process for each applicable digit. Press ENTER to confirm
the selection and exit the field.
If you are attempting to edit the configuration and the following message appears after pressing
ENTER, this field is currently under uplink control and cannot be changed from the front panel.
Press any button to continue.
DSR-6400 Series
MPEG SELECT PR
E 1
Channel configured by uplink
Press any button to continue
Program
00000(Not in map)
Default: 1
 
53