Audio1 And Audio2 Menus; Audiomix Field - Motorola DSR-6403 Operator's Manual

3

Audio1 and Audio2 Menus

Use these menus to customize the back-panel analog audio outputs (Phoenix connectors). Press
the  buttons until the Audio1 or Audio2 menu appears (shown below).

AudioMix Field

Important: If the audio input mode is stereo and you are connecting to a mono modulator, you
must set this field to Mono.
This field allows selection of the audio processing options. Press the 4 button until the cursor is
at the AudioMix label, and press ENTER to move into the field. Press the  buttons to display
the options:
Stereo
Dual Mono
Mono
Surround
Caution: If Dual Mono is selected, a caution screen appears. If Dual Mono is selected and then
changed to another option, the caution screen appears again. This caution message denotes possible
conflicts between this menu and the language selection menus that could mute the audio. By
pressing ENTER (ignoring the caution), the unit changes to Dual Mono, and uses the language
previously selected for Mono (or Stereo) for both left and right channels.
If it is necessary to select a single language for Mono, Dual Mono, or Stereo output, see
"AUD1LANG and AUD2LANG Menus" on page 54.
38
 AUDIO1  AudioMix  DialNorm/Compress
E Stereo On-Moderate
 AUDIO2  AudioMix  DialNorm/Compress
E Stereo On-Moderate
Default: Stereo
Stereo output on both left and right channels
Mono output on both left and right channels that can each be assigned to a
unique language
Duplicate mono output on both left and right channels
Enhanced stereo with surround pass-through
CAUTION: Check audio language selection
Press E to continue or to stop