Gige Input Ip Addr Field; Rf Input; Input Field - Motorola DSR-6403 Operator's Manual

3

GigE Input IP Addr Field

Use the following procedure to set and view the Input GigE IP address of the unit. Press the 
buttons until the GigE Input IP Address menu appears. Use this menu to enter an IP address and
Port for the incoming GigE source stream. The address is represented in the common dotted-
decimal format. Contact the network administrator for details about configuring the GigE input
port for the desired source stream.
Important: Do not configure the IP Address of the 10/100 and GigE to be on the same subnet.
Press the 4 button until the cursor is at the IP Address label, and press ENTER to move into the
field. Use the arrow buttons ( 4 ) to enter the desired address and then press ENTER to
confirm the selection and exit the field. Skip to page 38 to set the remaining installation fields.

RF Input

Use this section to select one of the eight RF input ports so that the unit can acquire the DigiCipher
II system signal and automatically download network data required for operation.
Because many satellite broadcasters use standard C-band transponder center frequencies,
selecting a transponder number is the default tuning mode. Use the Xpndr option in the Mode
field and edit the Xpndr (transponder) field (described on page 33), for tuning such
For offset-frequency C-band, fractional transponders, or Ku-band satellite broadcasts, use the
LFreq field in the Mode field (described on page 34), and directly edit the L-band frequency field.
The unit does not actually require any distinction between C-band and Ku-band satellite signals in
order to tune and acquire a compatible signal. However, correct modulation information is
necessary. For details on modulation, see "Modulation Menu" on page 35.

Input Field

The Input field displays the active input. To select the input:
Press the 4 button until the cursor is at the Input label and press ENTER. Press the  buttons to
scroll to the input that is connected. Unless changed, the unit displays Port 1. Press ENTER to confirm
the selection and return to the top line of the menu. If Port 1 through Port 8 is selected, then use the
arrow buttons ( 4 ) to specify the other fields (Mode field, Xpndr field, and Lfreq field) as
needed. These three fields are not visible when ASI In or GigE In is selected.
32
Default: 239.001.001.001
GigE Input IP Address
E 239.001.001.001
Default: Port 1
MANUAL TUNE Input Mode Xpndr LFreq
E Port 1 Xpndr 01
Port
00000
1430.00
signals.