Installation; Connecting The Satellite Dish, Receiver, And Tv; Using The Menus - Motorola DSR315 User Manual

Digital satellite receivers

Hide thumbs Also See for DSR315:

Table of Contents

Complete the following steps, and make sure that the satellite receiver is not

plugged into a power source before you connect any cables to the receiver:

• Connect the cable from the satellite dish to the satellite terminal on the satellite

receiver's back panel. connect the supplied three-wire (red, yellow, and white)

cable from the TV terminal on the satellite receiver's back panel to TV IN (or

coaxial cable to VHF IN) terminal on your TV.

• On the back panel of the satellite receiver, set the CH3 CH4 switch which is

located just above the TV terminal— to the same channel that you set on your

TV for use with your VCR.

• Turn on the TV and tune it to channel 3 or 4 to match the position of the switch

on the back panel of the satellite receiver.

• Plug the satellite receiver power cord into a standard power outlet. Wait one

minute, and then press the POWER key on the left side of the satellite

receiver's front panel.

You will be making various adjustments to your receiver using the keys on the

remote control or receiver.

If you use the keys on the remote control to control the menus, there are two ways

to select a menu option:

• Press the

keys or the

select. Then press the ENTER key to select it.

• If the options are numbered, simply press the number key for an option.

DSR315 User Guide

Installation

keys to highlight the option you wish to

Table of Contents