4Th Relay Menu (Dsr-6404 Only); Config Field; Asi Output Menu; Enable Field - Motorola DSR-6403 Operator's Manual

3

4th Relay Menu (DSR-6404 only)

Use this menu to repurpose the Alarm Relay (on the back panel) for use as the fourth contact
closure output. To pins are labeled NO, CM, and NC and are located below the ALARM label, as
shown in on page 16.

Config Field

Use the Config field to choose the purpose of the fourth relay. Press the 4 button until the cursor
is at the Config label, and press ENTER to move into the field. Press the  buttons to display
the two options:
Alarm
Ad Insertion

ASI Output Menu

Press the  buttons until the ASI Output menu appears. Use this menu to configure the digital
ASI OUT 1 on the back panel.

Enable Field

Note: The ASI OUT 1 on the back panel can be disabled by control information from the Uplink
Programmer (Broadcast Network Controller [BNC]).
Use this field to enable or disable the ASI OUT 1 on the back panel. The ASI OUT 2 on the back
panel is not affected by this setting and always remains enabled. When ASI output is disabled by
the BNC, this field is not editable and displays Lock Off. Otherwise, if the BNC enables the ASI
output, this field is editable with the default value (On). Press the  buttons to display the
options (On and Off).
Note: For PID values associated with ASI output ports, see "PID Mapping" on page 15.
42
4th RELAY Config
E Alarm
Default: Alarm
Enables alarm functionality for the fourth relay and disables ad
insertion functionality.
Enables ad insertion functionality for the fourth relay and disables
alarm functionality.
ASI OUTPUT Enable
E On
Default: On