Status2 Menu; Source Field; Channel Field; Quality Field - Motorola DSR-6403 Operator's Manual

Status2 Menu

This menu only applies to RF input. Press the  buttons until the STATUS2 menu appears. This
screen displays the source name, channel number, and the signal quality of the incoming signal.

Source Field

This status-only field displays the source name, which was entered by the programmer or network
operator at the encoder/uplink to identify the source. Dashes are displayed when no information
is available.

Channel Field

This status-only field displays the selected Virtual Channel number (from the Channel menu).
Dashes are displayed when no information is available.

Quality Field

This status-only field displays a number from 1 to 100 so that the quality level of the signal can be
judged. The signal quality is also displayed as a large bar graph in the Status3 menu. If it is 35 or
less, take action at your site to increase the dish size or improve the Low Noise Block (LNB) to
prevent occasional loss of output.

Status3 Menu

This menu only applies to RF input. Press the  buttons until the STATUS3 menu appears. This
screen displays the quality level of the signal as a large bar graph that expands to fill the entire LCD
screen. The following example shows the quality at about 75.
DSR-6400 Series
 STATUS2
Source
E ---
 STATUS3
Signal Quality
E |||||||||||||||||||||||.......
Channel Quality
---- ---
65