Channel Menus; Pr Field (Dsr-6402, Dsr-6403, And Dsr-6404 Only); Vct Field; Chnl Field - Motorola DSR-6403 Operator's Manual

Channel Menus

Press the  buttons until the Channel menu appears. Use this menu to view or select active
VCTs, Virtual Channels, and their corresponding transponder names.

PR Field (DSR-6402, DSR-6403, and DSR-6404 only)

The PR (processor) field does not appear on a DSR-6401. Press the 4 button until the cursor is at the
PR label, and press ENTER to move into the field. Press the  buttons to scroll through the
available processor values. Press ENTER to confirm the selection and exit the field. Each PR number
has its own VCT and Channel (CHNL) fields, for manual assignment to each processor path.
Note: Changing this value will change all other PR fields throughout this unit's menu system to
the same value that is set here.

VCT Field

Use this field to select a Virtual Channel Table (VCT) number. Contact the program provider for
the correct VCT number to enter for that encoder system. Press the 4 button until the cursor is at
the VCT label, and press ENTER to move into the field. While ensuring that the cursor remains
on the up/down symbol ( ), press the  buttons to scroll throughout the available VCTs. (If
the network has four VCTs, then only four VCTs appear in this field.) Press ENTER to confirm
the selection and exit the field.
This field also provides a second method for entering the VCT. To edit the field, use the 4
buttons to select the digit to change and then, while the cursor is on that digit, press the 
buttons to display the required value. Repeat this process for each applicable digit. Press ENTER
to confirm the selection and exit the field.
If the following message appears after pressing ENTER, this field is currently under uplink
control and cannot be changed from the front panel. Press any button to continue. If a unit is
under uplink channel control, this field and CHNL field become read-only.

CHNL Field

Use the Channel field to select the Virtual Channel for the output service. The unit supports
channel values from 0000 to 4095. Press the 4 button until the cursor is at the Channel label, and
press ENTER to move into the field. While ensuring that the cursor remains on the up/down
 
symbol ( ), press the  buttons to scroll through the available Virtual Channels. (If the chosen
VCT contains twenty-four Virtual Channels, then only twenty-four Virtual Channels appear in
this field.) Press ENTER to confirm the selection and exit the field.
DSR-6400 Series
CHANNEL PR VCT
E 1 00000
 
Channel configured by uplink
Press any button to continue
CHNL Xpndr
0000 (MPEG mode)
Default: 1
51