Table of Contents
Advertisement
Examples
NOTES
Set Auto-negotiation State
Command Name
Description
Syntax
Parameters
Examples
NOTES
Set Priority State
Command Name
Description
Syntax
Parameters
Examples
NOTES
Set Flow Control
Command Name
Description
Syntax
Parameters
Examples
NOTES
Set Name
Command Name
Description
Syntax
Parameters
Examples
NOTES
Set PVID
Command Name
Description
Syntax
Parameters
(Revised 2011-07-20)
Port number (1 ~ 24).
N-TRON/Admin#[1]> port get autonego 6
Auto negotiation mode is : [enabled]
N-TRON/Admin#[2]> port get autonego 24
Auto negotiation mode is : [disabled]
Check whether port-no is in the valid range. (1 ~ 24)
port set autonego
Sets the auto negotiation mode of a given port to either enable or disable. If
the port auto negotiation mode is enabled, the switch can automatically
adjusts it speed and duplex mode to the incoming speed and duplexmode.
port set autonego <port-no><enable | disable>
port-no
port number (1 ~ 24)
enable | disable
Auto negotiation enable or disable
N-TRON/Admin#[1]> port set
Auto negotiation mode of port[6] is : [enabled]
N-TRON/Admin#[2]> port set
Auto negotiation mode of port[6] is : [disabled]
Check whether port-no is in the valid range. (1 ~ 24)
port set prioritystate
Enables or Disables the Priority State on a per port basis.
port set prioritystate <enable | disable><port-no>
port-no
port number (1 ~ 26)
enable | disable
Priority State enable or disable
N-TRON/Admin#[1]> port set prioritystate enable 6
Check whether port-no is in the valid range. (1 ~ 26)
port set flowcontrol
Enable or Disable flow control (typically refers to 100Base). When
enabled a pause frame will be sent to help control the flow.
port set flowcontrol <port-no><enable | disable>
port-no
port number (1 ~ 24)
enable | disable
Flow Control enable or disable
N-TRON/Admin#[1]> port set flowcontrol 6 enable
Check whether port-no is in the valid range. (1 ~ 24)
port set name
Changes the name of the port. This change will only be visible in the CLI.
port set name <port-no><name>
port-no port number (1 ~ 26)
name
A string that describes the port
N-TRON/Admin#[1]> port set name 6 waterplant
This will be reset if you change a slot configuration.
port set pvid
Set a port‟s VLAN-ID.
port set pvid <port-no><pvid-number>
port-no
port number (1 ~ 26)
autonego 6 enable
autonego 24 disable
page 111 of 145
Advertisement
Table of Contents
