Cisco MDS 9216 Hardware Installation Manual page 89

Chapter 3 Connecting the Cisco MDS 9216 Switch
Send documentation comments to mdsfeedback-doc@cisco.com.
Figure 3-2
To connect the COM1 port to a modem, follow these steps:
Step 1 Connect the modem to the COM1 port using the adapters and cables provided
with the accessory kit, as follows: connect the DB-9 serial adapter labeled for use
with the Cisco MDS 9216 Switch to the COM1 port, connect the RJ-45 to DB-25
modem adapter to the modem, then connect the adapters using the RJ-45 to RJ-45
rollover cable (or equivalent crossover cable).
Note
If the default settings for the COM1 port have been modified, refer to the Cisco
Step 2
MDS 9000 Family Configuration Guide for information regarding verifying and
resetting the default settings.
78-16165-01
Connecting to the COM1 Port on the Cisco MDS 9216 Switch
MDS 9216
1
1 2 3 4
FAN
STATUS
2
1 2 3 4
FAN-MOD-2
Use the green DB-9 adapter that is specifically labeled for use with the
Cisco MDS 9216 Switch. If this adapter is not included in the accessory
kit, you can request one from your customer service representative.
Cisco MDS 9216 Switch Hardware Installation Guide
5 6 7 8 9 10 11 12
5 6 7 8 9 10 11 12
Connecting to the COM1 Port
CONSOLE MGMT 10/100 COM1
13 14 15 16
13 14 15 16
3-5