Connecting To A Fibre Channel Port - Cisco MDS 9216 Hardware Installation Manual

Chapter 3 Connecting the Cisco MDS 9216 Switch
Send documentation comments to mdsfeedback-doc@cisco.com.
Step 1
Step 2

Connecting to a Fibre Channel Port

78-16165-01
Figure 3-3 Connecting to the MGMT 10/100 Ethernet Port on the Cisco MDS
9216 Switch
MDS 9216
1
1 2 3 4
FAN
STATUS
2
1 2 3 4
FAN-MOD-2
To connect the MGMT 10/100 Ethernet port to an external hub, switch, or router,
follow these steps:
Connect the appropriate modular cable to the MGMT 10/100 Ethernet port:
Use modular, RJ-45, straight-through UTP cables to connect the 10/100
•
management port to an Ethernet switch port or hub.
Use a cross-over cable to connect to a router interface.
•
Connect the other end of the cable to the device.
The Fibre Channel ports on the switch modules are compatible with LC-type
fiber-optic SFP transceivers and cables (see
the Fibre Channel ports to connect to the SAN or for in-band management. For
information about configuring the switch for inband management, refer to the
Cisco MDS 9000 Family Configuration Guide.
5 6 7 8 9 10 11 12
5 6 7 8 9 10 11 12
Figure 3-4 on page
Cisco MDS 9216 Switch Hardware Installation Guide
Connecting to a Fibre Channel Port
CONSOLE MGMT 10/100 COM1
13 14 15 16
13 14 15 16
M G M T 1 0
/1 0 0
3-9). You can use
3-7