Cisco MDS 9216 Hardware Installation Manual page 61

Chapter 2 Installing the Cisco MDS 9216 Switch
Installing the Chassis in the Rack
Send documentation comments to mdsfeedback-doc@cisco.com.
Figure 2-3 Close-up of C Brackets for the Cisco MDS 9216 Switch
Step 3 Position the chassis in the rack, inserting the rear of the chassis between the front
mounting rails (see Figure 2-4), and use the 12-24 x 3/4-inch or 10-32 x 3/4-inch
screws (depending on the type of rack) to attach the L brackets to the mounting
rails (three per side).
If you are installing the optional cable guides, place the cable guides in front of
the L brackets, then pass the screws through the cable guides, L brackets, and
mounting rail. You can install one or both cable guides; a single cable guide can
be installed on either side.
Cisco MDS 9216 Switch Hardware Installation Guide
2-11
78-16165-01