Removing A Power Supply; Installing A Power Supply - Cisco MDS 9216 Hardware Installation Manual

Removing and Installing Components
Send documentation comments to mdsfeedback-doc@cisco.com.
Warning
Warning
Note

Removing a Power Supply

Step 1
Step 2
Step 3
Step 4
Step 5
Cisco MDS 9216 Switch Hardware Installation Guide
2-28
This section provides the following information:
Removing a Power Supply, page 2-28
•
Installing a Power Supply, page 2-29
•
A flat-blade or number 2 Phillips-head screwdriver is required to perform these
procedures.
Voltage is present on the backplane when the system is operating. To reduce
risk of an electric shock, keep hands and fingers out of the power supply bays
and backplane areas. Statement 166
Power supply captive installation screws must be tight to ensure protective
grounding continuity. Statement 289
You can replace the faulty power supply while the system is operating if the other
power supply is functioning.
To remove a power supply, follow these steps:
Turn the power switch to the off (0) position on the power supply you are
removing.
Loosen the screw on the power cable retainer and disconnect the power cable from
the power supply being removed.
Loosen the captive screw on the power supply.
Grasp the power supply handle with one hand and slide the power supply out of
the chassis.
If the power supply bay is to remain empty, install a blank filler panel over the
opening.
Chapter 2 Installing the Cisco MDS 9216 Switch
78-16165-01