Removing And Installing Components - Cisco MDS 9216 Hardware Installation Manual

Chapter 2 Installing the Cisco MDS 9216 Switch
Send documentation comments to mdsfeedback-doc@cisco.com.
Note
Step 11
Step 12
Note

Removing and Installing Components

Warning
Caution
78-16165-01
If you purchased this product through a Cisco reseller, contact the reseller directly
for technical support. If you purchased this product directly from Cisco, contact
Cisco Technical Support at this URL:
http://www.cisco.com/warp/public/687/Directory/DirTAC.shtml.
Verify that the system software has booted and the switch has initialized without
error messages. If any problems occur, refer to the Cisco MDS 9000 Family
Troubleshooting Guide or the Cisco MDS 9000 Family System Messages Guide.
If you cannot resolve an issue, contact your customer service representative.
For future reference, complete the worksheets provided in
Planning and Maintenance
A setup utility automatically launches the first time you access the switch and
guides you through the basic configuration. For instructions about how to
configure the switch and check module connectivity, refer to the Cisco MDS 9000
Family Configuration Guide.
This section provides the following information:
Removing and Installing Switching and Services Modules, page 2-22
•
Removing and Installing Power Supplies, page 2-27
•
Removing and Installing the Fan Module, page 2-31
•
Hazardous voltage or energy is present on the backplane when the system is
operating. Use caution when servicing. Statement 1034
To prevent ESD damage, wear grounding wrist straps during these procedures and
handle modules by the carrier edges only.
Removing and Installing Components
Records".
Cisco MDS 9216 Switch Hardware Installation Guide
Appendix D, "Site
2-21