Displaying Mstp Statistics And Configuration; Displaying Mstp Statistics - HP PROCURVE 2610 Advanced Traffic Management Manual

Spanning-Tree Operation
802.1s Multiple Spanning Tree Protocol (MSTP)
9. To view the current pending MSTP configuration, use the show spanning-

Displaying MSTP Statistics and Configuration

Command
MSTP Statistics:
MSTP Configuration

Displaying MSTP Statistics

Displaying Switch Statistics for the Common Spanning Tree. This
command displays the MSTP statistics for the connections between MST
regions in a network.
Syntax: show spanning-tree
Syntax: show spanning-tree < port-list >
5-74
tree pending command (page page 5-80).
show spanning-tree [< port-list >]
show spanning-tree instance < ist | 1..16 >
show spanning-tree [ port-list ] config
show spanning-tree [ port-list ] config instance < ist | 1..16 >
show spanning-tree mst-config
show spanning-tree pending< < instance | ist > | mst-config >
This command displays the switch's global and regional
spanning-tree status, plus the per-port spanning-tree
operation at the regional level. Note that values for the
following parameters appear only for ports connected to active
devices: Designated Bridge, Hello Time, PtP, and Edge.
This command displays the spanning-tree status for the
designated port(s). You can list data for a series of ports and
port trunks by specifying the first and last port or trunk of any
consecutive series of ports and trunks. For example, to display
data for port A20-A24 and trk1, you would use this command:
show spanning-tree a20-trk1
Page
below
76
77
78
79
page
5-80