HP PROCURVE 2610 Advanced Traffic Management Manual page 91

Viewing the Current IGMP Configuration. This command lists the IGMP
configuration for all VLANs configured on the switch or for a specific VLAN.
Syntax:
(For IGMP operating status, see the appendix on monitoring and analyzing
switch operation in the Management and Configuration Guide.)
For example, suppose you have the following VLAN and IGMP configurations
on the switch:
VLAN ID VLAN Name
1
22
33
You could use the CLI to display this data as follows:
Figure 4-1. Example Listing of IGMP Configuration for All VLANs in the Switch
The following version of the show ip igmp command includes the VLAN ID
(vid) designation, and combines the above data with the IGMP per-port
configuration:
show ip igmp config
IGMP configuration for all VLANs on the switch.
show ip igmp < vid > config
IGMP configuration for a specific VLAN on the switch,
including per-port data.
show ip igmp group < ip-address >
Lists the ports on which the specified multicast group
IP address is registered.
IGMP
Enabled
DEFAULT_VLAN Yes
VLAN-2 Yes
VLAN-3 No
Multimedia Traffic Control with IP Multicast (IGMP)
CLI: Configuring and Displaying IGMP
Forward with Querier
High Priority
No No
Yes Yes
No No
4-7