HP PROCURVE 2610 Advanced Traffic Management Manual page 327

2. To learn or verify the MAC address of the Member you want to move,
You will then see the Stacking Status (All) screen:
Figure 8-12. Example of How the Stacking Status (All) Screen Helps You Find
Member MAC Addresses
3. In the Stacking Status (All) screen, find the Member switch that you want
4. Display the Commander's Stack Management screen by selecting
5. Press
6. Either accept the displayed switch number or enter another available
display a listing of all Commanders, Members, and Candidates in the
subnet by selecting:
2. Stacking Status (All)
This column lists the MAC
Addresses for switches
discovered (in the local
subnet) that are configured
for Stacking.
to move and note its MAC address, then press
the Stacking Menu.
4. Stack Management
(For an example of this screen, see figure 8-9 on page 8-19.)
(for Add) to add the Member. You will then see a screen listing
[A]
any available candidates. (See figure 8-10 on page 8-19.) Note that you
will not see the switch you want to add because it is a Member of another
stack and not a Candidate.)
number. (The range is 0 - 15, with 0 reserved for the Commander.)
ProCurve Stack Management
Configuring Stack Management
For status descriptions, see the table on page 8-47.
Using the MAC addresses for these
Members, you can move them between
stacks in the same subnet.
(for Back) to return to
[B]
8-21