HP PROCURVE 2610 Advanced Traffic Management Manual page 42

Static Virtual LANs (VLANs)
Port-Based Virtual LANs (Static VLANs)
Figure 2-11. The Default VLAN Support Screen
2. Press
■
■
■
N o t e
For optimal switch memory utilization, set the number of VLANs at the
number you will likely be using or a few more. If you need more VLANs later,
you can increase this number, but a switch reboot will be required at that time.
3. Press [Enter] and then [S] to save the VLAN support configuration and
2-16
(for Edit), then do one or more of the following:
[E]
To change the maximum number of VLANs, type the new number. (For
the maximum number of VLANs allowed, refer to table 2-1 on page 2-4.)
To designate a different VLAN as the primary VLAN, select the Primary
VLAN field and use the space bar to select from the existing options.
To enable or disable dynamic VLANs, select the GVRP Enabled field and
use the Space bar to toggle between options. (For GVRP information, see
chapter 3, "GVRP".)
return to the VLAN Menu screen.
If you changed the value for Maximum VLANs to support, you will see an
asterisk next to the VLAN Support option (see below).