HP PROCURVE 2610 Advanced Traffic Management Manual page 92

Multimedia Traffic Control with IP Multicast (IGMP)
CLI: Configuring and Displaying IGMP
IGMP Configuration
for the Selected
VLAN
IGMP Configuration
On the Individual
Ports in the VLAN
Figure 4-2. Example Listing of IGMP Configuration for A Specific VLAN
Enabling or Disabling IGMP on a VLAN. You can enable IGMP on a
VLAN, along with the last-saved or default IGMP configuration (whichever
was most recently set), or you can disable IGMP on a selected VLAN. Note
that this command must be executed in a VLAN context.
Syntax:
For example, here are methods to enable and disable IGMP on the default
VLAN (VID = 1).
ProCurve(config)# vlan 1 ip igmp
ProCurve(vlan-1)# ip igmp
ProCurve(config)# no vlan 1 ip igmp
N o t e
If you disable IGMP on a VLAN and then later re-enable IGMP on that VLAN,
the switch restores the last-saved IGMP configuration for that VLAN. For more
on how switch memory operates, see the chapter on switch memory and
configuration in the Management and Configuration Guide.
4-8
[no] ip igmp
Enables IGMP on VLAN 1.
Same as above.
Disables IGMP on VLAN 1.