HP PROCURVE 2610 Advanced Traffic Management Manual page 132

Spanning-Tree Operation
802.1D Spanning-Tree Protocol (STP)
Read-Only Fields
Figure 5-7. Enabling Spanning-Tree Operation
6. If the remaining STP parameter settings are adequate for your network,
7. Use
8. Repeat step 7 for each additional parameter you want to change.
9. When you are finished editing parameters, press
10. Press
5-24
go to step 10.
or the arrow keys to select the next parameter you want to
[Tab]
change, then type in the new value or press the Space Bar to select a value.
(If you need information on STP parameters, press
Actions line, then press
Note: For information on the Mode parameter, see "STP Fast Mode" on
page 5-30.
Actions line.
[S] to save the currently displayed STP parameter settings. You will
then see the "Switch Configuration Menu" with an asterisk (
Spanning Tree Operation line, indicating that you must reboot the switch
before the Protocol Version change (step 5) takes effect.
Use this field to enable spanning tree.
to get help.)
H
to select the
[Enter]
to return to the
[Enter]
*
) at the