Download Print this page

Advertisement

Spanning-Tree Operation
Configuring Rapid Reconfiguration Spanning Tree (RSTP)

CLI: Configuring RSTP

Spanning Tree Commands in This Section
show spanning-tree config
spanning-tree
show spanning-tree
Viewing the Current Spanning Tree Configuration. Use this command
to display the current spanning tree configuration.
Syntax:
In the default configuration, the output from this command appears similar to
the following:
5-14
protocol-version <rstp | stp>
force-version
<rstp-operation | stp-compatible>
forward-delay <4 - 30>
hello-time <1 - 10>
maximum-age <6 - 40>
priority <0 - 15 | 0 - 65535>
<[ethernet] port-list>
path-cost <1 - 200 000 000>
priority <0 - 15 | 0 - 65535>
edge-port
point-to-point-mac
mcheck
mode <norm | fast>
show spanning-tree configuration
Lists the switch's full spanning tree configuration,
including whole-switch and per-port settings, regardless
of whether spanning tree is disabled.
(Default: n/a; Abbreviated Command: sho span config)
STP RSTP Page for RSTP Use
Y
Y
Below on this page
Y
Y
page 5-15
Y
Y
page 5-16
N
Y
page 5-16
Y
Y
page 5-16
Y
Y
page 5-16
Y
Y
page 5-16
Y
Y
page 5-16
Y
Y
page 5-18
Y
Y
page 5-18
Y
Y
page 5-18
N
Y
page 5-18
N
Y
page 5-18
N
Y
page 5-18
Y
N
Refer to "802.1D Spanning-
Tree Protocol (STP)" on page
5-23.
This command lists additional RSTP/STP/
MSTP monitoring data that is not covered in
this section. Refer to the section titled
"Spanning Tree Protocol Information" in the
"Monitoring and Analyzing Switch
Operation" appendix of the Management and
Configuration Guide for your switch.

Advertisement

Table Of Contents

Troubleshooting

   Also See for HP PROCURVE 2610

   Related Manuals for HP PROCURVE 2610

Comments to this Manuals

Symbols: 0
Latest comments: