HP PROCURVE 2610 Advanced Traffic Management Manual page 146

Spanning-Tree Operation
802.1D Spanning-Tree Protocol (STP)
Figure 5-17. The Spanning Tree Operation Screen
4. On the ports and/or trunks you want to use for redundant fast uplink
5-38
connections, change the mode to
(using ports A2 and A3) provide the redundant uplinks for STP:
a. Press (for ), then enable STP on the switch by using the Space
[E] Edit
bar to select in the Spanning Tree Enabled field.
Yes
b. Use [Tab] to move to the Mode field for port A1.
c. Use the Space bar to select
d. Use [v] to move to the Mode field for Trk1.
e. Use the Space bar to select
f. Press to return the cursor to the Actions line.
[Enter]
In this example, ports 2 and 3 have
already been configured as a port
trunk (Trk1), which appears at the end
of the port listing.
All ports (and the trunk) are in their
default STP configuration.
Note: In the actual menu screen, you
must scroll the cursor down the port
list to view the trunk configuration
(ports A2 and A3).
. In this example, port A1 and Trk1
Uplink
as the mode for port A1.
Uplink
Uplink as the Mode for Trk1.