Displaying Vrrp Configuration Information And Statistics; Displaying Configuration Information - HP ProCurve 9304M Manual Supplement

Displaying VRRP Configuration Information and Statistics

You can use the CLI or Web management interface to display configuration information and statistics for VRRP.

Displaying Configuration Information

To display VRRP configuration information for an HP routing switch, use one of the following methods.
USING THE CLI
To display VRRP configuration information for a router, enter the following command:
Router1(config)# show ip vrrp
Here is an example of the information displayed by this command:
Total number of VRRP routers defined: 1
Interface ethernet e 1/6
auth-type no authentication
VRID 1
state master
administrative-status activated
mode owner
priority 255
current priority 255
hello-interval 1 sec
ip-address 192.53.5.1
USING THE WEBMANAGEMENT INTERFACE
To display VRRP configuration information, select VRRP from the System configuration sheet. A panel such as
the ones shown in Figure 5 and Figure 6 is displayed.
• To modify an entry, select Modify.
• To delete an entry, select Delete.
NOTE: If you delete the real IP address associated with a VRRP entry, the VRRP entry also is deleted
automatically.
Configuring VRRP
19