Table of Contents
Advertisement
Installation Quick Reference
Installation Quick Reference
Installing the WLSE 1130-19 in a Rack
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
3-2
Table 3-1
provides a high-level overview of the installation process. After
installation is complete, follow the directions in
Setup—CiscoWorks 1105/1130/1130-19."
Table 3-1
Quick Reference
Task
Use the rack mount kit to install
the WLSE in a rack.
Connect the WLSE to an AC
power source.
Connect network and console
cables.
Power on the WLSE.
This section provides instructions for installing the WLSE in a rack. The rack
must be properly secured to the floor, ceiling, or upper wall, and where applicable,
to adjacent racks. The rack should be secured using floor and wall fasteners and
bracing specified by industry standards.
Before installing the WLSE in a rack, read
page 2-7
to familiarize yourself with the proper site and environmental
conditions. Failure to read and follow these guidelines could lead to an
unsuccessful installation and possible damage to the system and components.
Perform the steps below when installing and servicing the WLSE.
The rack must be properly secured to the floor, to the ceiling or upper wall, and
where applicable, to adjacent racks. The rack should be secured using floor and
wall fasteners and bracing specified or approved by the rack manufacturer or by
industry standards.
Chapter 3
Installing WLSE 1130-19 Hardware
Chapter 4, "Basic
References
Installing the WLSE 1130-19 in a Rack,
page 3-2
Connecting Cables, page 3-15
Connecting Cables, page 3-15
Powering On the WLSE, page 3-16
Preparing Your Site for Installation,
78-16345-01
Advertisement
Table of Contents
