Install The Hard Drive Cage - Fujitsu SPARC ENTERPRISE T5140 Service Manual

13. Lift the hard drive cage up and out of the chassis.
14. Set the hard drive cage on an antistatic mat.
Related Information
"Install the Hard Drive Cage" on page 154
■
"Remove the Hard Drive Backplane" on page 157
■

▼ Install the Hard Drive Cage

Before performing any installation steps, review the proper cable routing and
connections. The following topics contain detailed cable routing information.
"Internal Cables for Onboard SAS Controller Cards in SPARC Enterprise T5140
■
Servers" on page 190
"Internal Cables for Onboard SAS Controller Cards in SPARC Enterprise T5240
■
Servers" on page 204
1. Position the hard drive cage in the chassis, over the chassis standoffs.
This is shown in the following figure.
154 SPARC Enterprise T5140 and T5240 Servers Service Manual • July 2009