Remove The Hard Drive Cage - Fujitsu SPARC ENTERPRISE T5140 Service Manual

You must remove the hard drive cage to access the following components:
Hard drive backplane
■
Front control panel light pipe assemblies
■
Related Information
"Remove the Hard Drive Cage" on page 152
■
"Install the Hard Drive Cage" on page 154
■
"Remove the Hard Drive Backplane" on page 157
■
"Remove the Front Control Panel Light Pipe Assemblies" on page 161
■

▼ Remove the Hard Drive Cage

1. Power off the system.
See
2. Disconnect all external cables.
3. Remove the server from the rack. Place the server on a hard, flat surface.
See
4. (SPARC Enterprise T5140) Remove the inner glides from the server.
Each inner glide is secured with a locking tab. Release the tab and slide each inner
glide off the server mounting studs.
5. Attach an antistatic wrist strap.
6. Remove the top cover.
See
7. If you are servicing the hard drive backplane, remove all hard drives.
See
Note – Make a note of the drive locations before removing them. You will need to
install the hard drives in the same locations when reassembling the system.
8. If you are servicing the hard drive backplane, remove the DVD/USB module.
See
152 SPARC Enterprise T5140 and T5240 Servers Service Manual • July 2009
"Removing Power From the System" on page
"Remove the Server From the Rack" on page
"Remove the Top Cover" on page
"Remove a Hard Drive" on page
"Remove the DVD/USB Module" on page
60.
64.
67.
71.
145.