Fujitsu SPARC ENTERPRISE T5140 Service Manual page 158

2. Lift the latch and open the top cover door.
Caution – The system might start to overheat if the top cover door is left open for
more than 60 seconds.
3. The faulty fan module is identified with a corresponding fault LED.
On SPARC Enterprise T5140 servers, the Fan Fault LEDs are located on the fan
board.
On SPARC Enterprise T5240 servers, the Fan Fault LEDs are located on the fan
modules.
4. Pull up on the green fan module label until you remove the fan module from
the chassis.
Caution – When changing the fan modules, only the fan modules may be removed
or replaced. Do not service any other components in the fan compartment unless the
system is shut down and the power cords removed. Pull up the fan module by
holding the green label only.
FIGURE:
132 SPARC Enterprise T5140 and T5240 Servers Service Manual • July 2009
Removing a Fan Module