Keyswitch_State Set To Normal; Keyswitch_State Set To Diag; Diag_Mode Set To Off; Diag_Mode Set To Service - Fujitsu SPARC ENTERPRISE T5140 Service Manual

Note – When you change individual POST parameter values, the
keyswitch_state value must be set to normal.

keyswitch_state Set to normal

You put POST in its default mode by setting the virtual keyswitch property to
normal. This enables the system to turn on and for POST to run.
-> set /SYS keyswitch_state=normal
Set 'keyswitch_state' to 'normal'

keyswitch_state Set to diag

You can apply preconfigured diagnostic settings to POST operations by setting the
virtual keyswitch property to diag.
-> set /SYS keyswitch_state=diag
Set 'keyswitch_state' to 'diag'

diag_mode Set to off

You can prevent POST from running by setting the diag_mode property to off.
-> set /SYS diag_mode=off
Set 'diag_mode' to 'off'

diag_mode Set to service

You force POST to run with a set of preconfigured values for diag_level and
diag_verbosity by setting the diag_mode property to service.
-> set /SYS diag_mode=service
Set 'diag_mode' to 'service'
Related Information
"ILOM Properties that Affect POST Behavior" on page 35
■
"Run POST in Maximum Mode" on page 39
■
"Clear POST-Detected Faults" on page 41
■
38 SPARC Enterprise T5140 and T5240 Servers Service Manual • July 2009