Fujitsu SPARC ENTERPRISE T5140 Service Manual page 150

a. Press the latching mechanism on the connector to release the cable plug.
b. Keeping the latching mechanism pressed, pull the plug from the connector
Caution – The hard drive data cables are delicate. Ensure they are safely out of the
way when servicing the motherboard.
12. If you are replacing the motherboard, remove the following components:
■
■
13. Using a No. 2 Phillips screwdriver, remove the four screws that secure the
motherboard assembly to the bus bar.
Caution – If you touch the heat sink when removing the bus bar screw, you might
get burned.
Note – Set the four screws aside. You must use these screws to attach the
motherboard to the bus bar during installation.
14. Loosen the captive screw securing the motherboard to the chassis.
The captive screw is green, and is located to the left of the bus bar screws.
15. Using the green handle, slide the motherboard toward the back of the system
and lift it out of the chassis.
Caution – Some components on the motherboard might be hot. Use caution when
handling the motherboard, especially near the CMP heat sinks.
124 SPARC Enterprise T5140 and T5240 Servers Service Manual • July 2009
If you have difficulty releasing the cable plug, first push the plug slightly into
the connector, then press the latching mechanism.
on the hard drive backplane.
All FB-DIMMs. Note memory configuration so that you can install the
FB-DIMMs in the replacement motherboard.
SCC PROM.