Prerequisites To Install Dell Ulnm On Citrix Xenserver 5.6 X86 Machine; Dell Ulnm Installation; Hardware Architecture; Network Architecture - Dell PowerEdge UPS 500T User Manual

2.2. PREREQUISITES TO INSTALL DELL ULNM ON CITRIX XENSERVER 5.6 X86
MACHINE
1. XenServer host having 5 MB free space.
2. Dell ULNM installation packages on XenServer
Notes:

XenServer and XenCenter should be of same version. For compatibility issues, refer
XenServer installation guide

To allow a graceful shutdown of the Virtual machines, you have to install PV Tools (XenTools)
on each virtual machine.

In case of resource pools, if the slave machine goes down, then master machine will continue
functioning. But if we shutdown master machine, all the guest machine in that pool will go
down and the pool will be out of action until master is rebooted.

2.3. DELL ULNM INSTALLATION

2.3.1. HARDWARE ARCHITECTURE

The prerequisites for Dell UPS Local Node Manager installation are described in the "Dell UPS Local
Node Manager – User Guide" document, in chapter: "Installation Prerequisites".
(http://dellups.com/). For UPS systems compatibility, please refer to the chapter "Appendix ->
Compatibility List" in this document.

2.3.2. NETWORK ARCHITECTURE

All hardware elements must have an operational network configuration that allows them to
communicate freely with each other.
Please make sure that the following TCP/UDP ports are enabled on XenSever Firewall:

Connections on tcp port 4679 and 4680 to enable a remote access for supervision and
configuration through Web Browser. These ports are reserved at IANA
(http://www.iana.org/).

Connections through TCP port 80. It must be opened as a destination port (for output) on the
machine hosting Intelligent Power Protector.
Dell ULNM - User guide extension - Xen Virtualized Architecture
rev0.01
Dell UPS Local Node Manager
USER'S GUIDE EXTENSION FOR XEN VIRTUALIZED ARCHITECTURE
Dellups.com
6