Using External Components; Connecting A Video Component With Dv Connector - JVC GY-DV700WUCL - Cineline Dv Camcorder Instruction Manual

11. USING EXTERNAL COMPONENTS

11-1Connecting a Video Component with DV Connector

Rear section of GY-DV700W
CH-1 AUDIO IN
DV
EARPHONE LINE MIC
+48V
ON
DC INPUT
DC OUTPUT
DV connector
When connecting the GY-DV700W to other component with DV connector, be sure to observe the following procedure.
When using the GY-DV700W as playback component
1.
Turn ON both units.
2.
Confirm that the VCR Setup Menu item No.126 INPUT
SELECT is set to "CAMERA"(cA).
* If set to "IEEE1394", set it to "CAMERA" and then turn
ON the power again.
3.
Insert the videocassette.
4.
Connect the DV cable.
Memo:
• When the GY-DV700W is controlled through the DV
connector, set the VCR Setup Menu item No.050
REMOTE SELECT to "IEEE1394".
However, the following functions may not work
depending on the component that the GY-DV700W
is connected to.
REC
FF (FWD search is possible)
REW (REV search is possible)
• When the DV cable is connected for communication
with another component, to stabilize the IEEE1394
output signal, the STILL mode is activated for a few
seconds and the LED of the STILL button on the top
section of the GY-DV700W lights when the mode is
switched to PLAY or x1 FWD search.
The x1 FWD search only works during IEEE1394
control or RS-232C control.
• The operation method differs with the characteristics
and specifications of the connected equipment. Even
if connection is possible, operation or data
communication may sometimes be impossible to
perform.
Note:
If the above procedure is not performed correctly, the playback picture may be disturbed or the sound may fall out. If this
happens, redo the connection by performing steps 1. to 4. described above.
64
CH-2
TALLY
LINE MIC
+48V
ON
DV cable
Video component with DV Connector
DV connector
When using the GY-DV700W as recording component
1.
Turn ON both units.
2.
Set the VCR Setup Menu item No.126 INPUT SELECT to
"IEEE1394"(iE).
3.
Insert the videocassette.
4.
Connect the DV cable.
Memo:
• When recording while controlling the GY-DV700W
through the DV connector from another component
with DV connector, set the VCR Setup Menu item
No.050 REMOTE SELECT to "IEEE1394".
In this case, it takes approximately 2 to 3 seconds
before recording starts on the GY-DV500.
• When video is input through the DV connector, the
EE picture is not displayed in the viewfinder.
When the GY-DV700W is used as camera, and a backup
recording is made on another component via the DV
connector, set the VCR Setup Menu item No.126 INPUT
SELECT to "CAMERA".