Table of Contents
Advertisement
6-2 Viewfinder Adjustment
CONT
PEAKING
BRIGHT
6-3 External Monitor Adjustment
PUSH
1.
3.~8.
SPOT L
SMTPE type color bars
White
Yellow
Cyan
Green Magenta
1
2
3
4
Blue
Black Magenta Black
8
9
0
A
Black
White
Black
E
F
G
6. SETTING AND ADJUSTMENTS BEFORE SHOOTING
Visibility adjustment
DV CAMCORDER
GY-DV700W
Y/C OUT MONITOR OUT LINE OUT
SYNC IN
TEST OUTPUT
CH-1
CH-2
VTR
REMOTE
TC IN
TC OUT
2.
COMPRESS
POWER
NG
ON
OFF
Red
Blue
5
6
7
Cyan
Black
White
B
C
D
H I J K
Visibility adjustment
Rotate the eyepiece focusing ring so that the viewfinder
screen image is clearly visible.
Brightness and contrast adjustment
When the ambient brightness changes, the brightness and
contrast of the viewfinder screen can be adjusted with the
CONT and BRIGHT controls.
Peaking adjustment
Turning the PEAKING (contour adjustment) control makes
the picture look sharper, making focus adjustment easier.
Display the camera built-in color bar signal on the video monitor
and adjust the colors, contrast and brightness.
1.
Connect a color video monitor to the MONITOR OUT
connector of the GY-DV700W.
2.
Set the OUTPUT switch to BARS to output the color bar
signal (SMTPE type color bars).
3.
Set the monitor's BLUE CHECK function to ON so that the
screen turns entirely blue.
4.
Adjust the CHROMA control of the monitor so that there is
MIC IN
LENS
no difference in brightness between the color bars 1 and
8, 7 and D.
5.
With the BLUE CHECK function ON, adjust the PHASE
control of the monitor so that there is no difference in
brightness between the color bars 3 and 0, 5 and B.
6.
If the phase control adjustment above causes a difference
in brightness between the color bars 1 and 8, 7 and D,
start again from the CHROMA control adjustment in step 4 .
7.
Set the monitor's BLUE CHECK function to OFF to switch
the monitor back to the standard screen (R, G and B will all
appear).
8.
Use the monitor's brightness control to adjust so that the
color bars H and I disappear but J is visible.
43
Advertisement
Table of Contents
