Cassette Loading And Unloading - JVC GY-DV700WUCL - Cineline Dv Camcorder Instruction Manual

5. PREPARATIONS

5-2 Cassette Loading and UnLoading

EJECT
EJECT switch
NG
ON
VTR switch POWER switch
• A cassette cannot be loaded or unloaded while the GY-DV700W is in POWER OFF mode.
• Use a videocassette tape marked MiniDV.
• The videocassette should be held vertical and inserted straight into the slot.
Loading the Cassette
1.
Set the POWER switch to ON.
2.
Slide the EJECT switch to the side to open the cassette
cover.
3.
Insert a videocassette into the cassette slot after removing
the tape slack.
Ensure that the videocassette is fully inserted.
The cassette indicator on the display blinks
during tape loading and lights steadily after
the loading has been completed.
4.
Slowly close the cassette cover by pushing it in all the way.
When the cassette cover is closed, the OPERATE LED
lights up green and the unit is in the condition where it can
be operated. In the SAVE mode, the OPERATE LED lights
orange.
• The condition at the completion of loading varies depending
on the position of the VTR switch and the switch on the back
of the videocassette as shown below.
Switch on Back of Videocassette
VTR switch
Enters record-
STBY
pause mode after
back-spacing.
In the record-pause
SAVE
mode and the drum
rotation is stopped.
* Recording can be started by pressing the VTR trigger button
from the record-pause condition. For details on how to record,
see page 50.
After the cassette cover is closed, it takes about 8 seconds
before the unit can start recording or before it enters the
stop mode.
40
LOG REW STOP FF PLAY STILL
POWER
OFF
REC
SAVE
The unit enters
stop mode.
" R E C I N H " i s
displayed for a few
seconds on the
counter display.
Cassette rear switch
CAUTION:
The GY-DV700W cannot be operated while the cassette
cover is open. Make sure to close the cover before
operating the unit.
Unloading the Cassette
1.
Set the POWER switch to ON.
2.
Slide the EJECT switch all the way to the side to start tape
ejection.
The cassette indicator on the display blinks
during tape ejection and turns off after the
ejection has been completed.
• It takes a few seconds before the cassette is ejected after
the EJECT switch is moved.
3.
Take out the videocassette.
4.
Close the cassette cover.
CAUTION:
Do not leave the unit for a long period with the cassette
cover open as dirt or other foreign objects may enter the
VCR section and cause malfunction.
Videocassette
Cassette
cover