Table of Contents
Advertisement
3-6 Attaching the Tripod Base (provided)
1.
Tripod mounting holes
Front mount clip
2.
Safety lever
4.
Front
base
mount
Front mount clip
SHUTTER
C
AUTO IRIS
3. BASIC SYSTEM CONNECTIONS AND ADJUSTMENTS
2.
Lock lever
3.
Rear base
mount
Pin
4.
OPERATE/WARNING
LIGHT
RESET
ON
OFF
MONITOR
FILTER
SELECT
COUNTER
1 3200k
CTL
ALARM
TC
2 5600k+1/8ND
UB
3 5600k
4 5600k+1/64ND
STATUS
MONITOR
MENU
CH-1
AUDIO
CH-2
LEVEL
FULL AUTO BLACK
LOLUX
BACK L
STRETCH
NORMAL
NORMAL
SPOT L
COMPRESS
NG
POWER
ON
OFF
Use the provided tripod base to place the camera on a tripod.
1.
Attach the tripod base on the tripod by using the hole that
balances the unit most optimally.
2.
While pushing the safety lever, pull the lock lever toward
the front until the front mount clip clicks into place.
3.
Place the unit on the tripod base by aligning the rear base
mount of the unit with the pin on the tripod base.
4.
Push the unit from the upward direction and slide it toward
the front so that the front base mount of the unit is locked
by the front mount clip of the tripod base as it clicks into
place.
CAUTION:
• The front base mount may be locked while the pin of the
tripod base is not inserted into the hole on the rear base
mount of the unit. Therefore, after mounting, make sure
that these parts are engaged properly.
• When moving the unit mounted on a tripod, any impact
or vibration should be avoided as this may cause the unit
to become detached and to drop from the tripod.
Be sure to remove the unit from the tripod before
transporting it.
• The tripod base (KA-510) cannot be mounted.
33
Advertisement
Table of Contents
