Using External Components; Connecting The Video Signal Cables; Connecting The Ieee1394 Cable - JVC GY-HD250U - 3-ccd Prohd Camcorder Instructions Manual

e_hd250.book Page 64 Tuesday, October 24, 2006 3:11 PM

USING EXTERNAL COMPONENTS

Connecting the Video
Signal Cables

Connecting the IEEE1394 Cable

To reduce the emission of unwanted radio waves, be sure to
attach the provided clamp filter as shown in the figure below.
• Attach the clamp filter as close to this device as possible,
as shown in the figure.
• Set the IEEE1394 switch on the left panel of this device.
DV : DV format
HDV : HDV format
Clamp filter
Wind once
CAUTION
When connecting the IEEE1394 cable from/to Camcorder,
VCR and other IEEE1394 device, make sure the following
instructions, otherwise the IEEE1394 circuit device may be
destroyed.
• Turn the power of both devices OFF and connect the
IEEE1394 cable.
• Do not insert incorrectly (in reverse) the IEEE1394 cable
end to IEEE1394 port of both devices.
• Do not connect the IEEE1394 cable under the condition
of static electricity.
• Turn the power of both devices OFF when changing the
IEEE1394 switch from/to HDV/DV.
64
IEEE1394 switch
X
Displaying Alarms
• CHANGE 1394 SWITCH
Displayed when the setting for the input/output video format
from the IEEE1394 connector and the setting for the
IEEE1394 switch are different.
Set the IEEE1394 switch so it matches the video format.
C H A N G E 1 3 9 4 S W I T C H