Using External Components; Connecting The Video Signal Cables; Connecting The Ieee1394 Cable - JVC GY-HD200UB - Camcorder - 1080i Owner's Manual

USING EXTERNAL COMPONENTS

Connecting the Video
Signal Cables

Connecting the IEEE1394 Cable

To reduce the emission of unwanted radio waves, be sure to
attach the provided clamp filter as shown in the figure below.
• Attach the clamp filter as close to this device as possible,
as shown in the figure.
• Set the IEEE1394 switch on the left panel of this device.
DV : DV format
HDV : HDV format
IEEE1394 switch
Clamp filter
Wind once
CAUTION
When connecting the IEEE1394 cable from/to Camcorder,
VCR and other IEEE1394 device, make sure the following
instructions, otherwise the IEEE1394 circuit device may be
destroyed.
• Turn the power of both devices OFF and connect the
IEEE1394 cable.
• Do not insert incorrectly (in reverse) the IEEE1394 cable
end to IEEE1394 port of both devices.
X
• Do not connect the IEEE1394 cable under the condition
of static electricity.
• Turn the power of both devices OFF when changing the
IEEE1394 switch from/to HDV/DV.
64
Displaying Alarms
• CHANGE 1394 SWITCH
Displayed when the setting for the input/output video format
from the IEEE1394 connector and the setting for the
IEEE1394 switch are different.
Set the IEEE1394 switch so it matches the video format.
Recording Composite
Video Signals from an
External Device
This device features an AUX IN terminal and can record
composite video signals from external devices.
GENLOCK/AUX IN switch
GENLOCK/AUX IN terminal
Connection
Input analog composite video signals from an external
device to the GENLOCK/AUX IN terminal.
MEMO
Input composite video signals with no jitter.
Input level: 1.0V ± 0.3V (p-p)
Setting
Set this device to camera mode:
If the VTR indicator is lit, press the [CAM/VTR] button and
turn off the indicator.
Set the GENLOCK/AUX IN switch to AUX IN.
Set REC on the VIDEO FORMAT[1/2] menu screen as fol-
lows.
U model: DV-60I
E model: DV-50I
Set SET UP item on the VIDEO FORMAT[2/2] menu
screen as follows. (Only for U model)
ON : Set to this when input analog signals include the
setup signal.
OFF : Set to this when input analog signals do not include
the setup signal.
Operation
Start and stop recording with the REC/VTR trigger button.
• EE images of input signals are output in DV-60I (U
model) or DV-50I (E model) formats from the various
image output terminals.
CAUTION
• Recording cannot be checked using the lens RET button
when recording external image signals.
• Do not touch GENLOCK/AUX IN switch during record-
ing.
Status Screen Display on the LCD Screen
or Viewfinder
• "AUX" is displayed at the top left with signal format (DV60I
or DV50I).
"AUX" display "AUX" display
D V - 6 0 I A U X D V - 6 0 I A U X
1 2 . 0
STATUS 0 screen STATUS 1 screen
65